Electrical · Installation and maintenance
Installed safely, tested and recorded
We install and maintain electrical systems on mining, industrial, commercial and domestic sites. Every job follows the same discipline: isolate, prove dead, inspect, test and document, so the next person knows exactly what was done.
Work through a safe isolation
Tick each check to move on. The next step stays locked until the one before it is complete, as it should on site.
1. Isolate
Make sure the circuit you work on cannot be switched on by anyone else.
Tick every check to unlock the next step.
Engineering advice you can act on
What you receive at each kind of engagement.
- 01
Design review
An independent check of drawings and calculations, with a list of findings ranked by risk.
- 02
Specifications
Clear technical specifications for equipment and installation work, ready to go out to suppliers.
- 03
Tender support
Technical evaluation of bids against the specification, so like is compared with like.
- 04
Site inspection
Condition surveys of boards, cables and equipment, with photographs and priorities.
- 05
Reports
Written reports your management, insurers or auditors can act on.
Installation, inspection or a maintenance plan?
Tell us about the site and the equipment, and we will scope the work.
Explore more